Gazco Important Safety Notice

(Supplement to important safety notice dated 18th September 2007)

1. DESIGNIO FRONT
1.1 If the Linea is fitted with a Designio front, access to the batteries can be achieved by simply dropping the lower front access cover
1.2 Remove the battery holder by sliding outwards, diagram 2
1.3 Open the battery holder. Slide lid across (if fitted), diagram 3
1.4 Remove batteries
1.5 Replace lid (if fitted) and fit the sticker provided onto the battery holder to prevent anyone replacing the batteries until authorised
1.6 Push the battery holder back into its location and close the door by following these instructions in reverse
2. PLANO OR VETRO FRONT
2.1 If the Linea is fitted with a Plano or Vetro front, access to the batteries can be achieved through the access hole in the casing below the unit. This is located on the left hand side, diagram 4
2.2 Using fingers, locate the plastic battery holder. Pull towards you and the holder will drop down through the access hole
2.3 Open battery holder. Depress the arrow on top of the plastic holder and slide the lid off (if fitted) in the direction of the arrow diagram 5
2.4 Remove batteries
2.5 Replace lid (if fitted) and fit the sticker provided onto the battery holder to prevent anyone replacing the batteries until authorised
2.6 Push the battery holder back into its location and close the door by following these instructions in reverse
Download instructions as PDF (345KB)